Email: sales@amtune.comTel: +86 755 8427 8955Language: Language

Industry-news


Dante Adapters Pull the Network Edge Into Analog Racks

WyreStorm launched five Dante and AES67 audio adapters on 16 November, all shipping through its distribution and reseller network. The set is deliberately symmetrical: the CON-ANLG-DNT takes two channels of balanced or unbalanced analog in and puts them on the network, the CON-DNT-ANLG does the reverse for amplifiers, powered speakers and analog DSP, the CON-XLR-DNT converts two XLR inputs with independent sensitivity and 48 volt phantom power, the CON-DNT-XLR brings network audio back out to XLR with selectable output gain, and the CON-USBC-DNT bridges a 2x2 USB audio device to Dante. All run 24-bit audio up to 96 kHz, all take Power over Ethernet, and the USB unit also runs from USB-C power with no driver install. Product manager Joseph Gagliardi described the intent plainly: most projects do not need a system redesign, they need a reliable way to get existing hardware on and off the network.

That is the correct diagnosis, because the analog rack is where networked audio projects stall. Designers draw a clean Dante diagram and then discover that the paging amplifier, the lectern microphone and the house 70 volt system are all analog, that the owner has no budget to replace any of them, and that the DSP has two spare input cards rather than eight. Adapters close that gap, but they change the arithmetic in ways that catch people out. These are two channel boxes. A rack with twenty-four analog inputs needs twelve of them, which is twelve PoE ports, twelve patch leads, twelve device names in the controller and twelve firmware records. Two eight-channel endpoints would be a different design conversation, and often a cheaper one once the switch, the rack space and the labelling are counted.

The technical details are where retrofits go wrong. Double the sample rate and each flow carries twice the payload, so a 96 kHz design has a different bandwidth budget than the 48 kHz drawing it replaced. The XLR input has phantom power, which means the adapter is a microphone preamp, so gain staging moves into a box that nobody climbs into the ceiling to adjust; set it once, document it, and leave headroom for the loudest service of the year. Clocking deserves the same discipline as before: one leader per domain, adapters as followers, and a written note on what happens if the leader disappears. Latency settings of 0.25, 0.5 and 1 millisecond are not interchangeable when one path feeds a delay ring and another feeds a confidence monitor. And the USB bridge is an audio path for a soft codec, not a replacement for a class-compliant interface with its own gain controls.

What belongs in the specification is therefore dull and useful: channel count per adapter, PoE class and total budget per rack, phantom power per input, sample rate and latency per flow, whether each device is unicast or multicast, and a naming convention that survives the next technician. Amtune builds the same edge from the other direction, with Dante and AES67 audio distribution at the head end, modular Dante cards for racks that need channel counts rather than adapters, AES67 modular I/O where the network is not Dante, and signal converters for the analog hardware that stays. The network edge is not a compromise. It is just the part of the drawing that gets less attention than the cloud dashboard.

CATEGORIES

LATEST NEWS

CONTACT US

Contact: Brook Fan

Phone: +86 159 8665 0800

Tel: +86 755 8427 8955

Email: sales@amtune.com

Add: Building A No. 6 Xiacun First Industrial Area Gongming Town Guangming Shenzhen City, China.

Leave a message

Facebook

LinkedIn

+86 755 8427 8955

brookvan

whatsapp

sales@amtune.com

673011865

Top